It is possible to make by using superconductor blank, then adding an obsidian facet to it, then acid-etching and forming the rings. A customer of his wanted this ring because they watched the video he made about another of his rings. The ring will be made for them. After only a couple of minutes of cutting on the bandsaw, he is able to cut into the steel. It is necessary to hand-sand the ring. This was his first use of two grinding wheels. It’s good to carry sanding belts around. As you do not want your rings to be perfectly round shape, you should be able and able to resize it as needed. It is very complicated. It’s incredibly difficult to get rid of the copper surrounding it. It is also recommended to have drill bits available. Since it is a tough material to handle, you’ll be able to swiftly go through them. Once you have this, the rest of the steps are simple. When you’ve got the middle cut out, it is important to hollow it out gradually so that it is the proper size and thickness. rqammnnozq.